phaze2
08-24-2005, 02:20 PM
Picked up the stuntfactory rear hand brake setup (taps into existing calipher instead of double calipher)
My question is basicaly how do i go about bleeding my rear brake system properly. Thanks.
Everett
08-24-2005, 05:30 PM
with all brakes start at the brake bleeder until you get nothign but brake fluid. if your brake is still soft make yoru way up to the resoviour at the bango and do the same thing. i know that with hand brake calipers, they tend to get air in them so if you cant get a firm brake then bleed every bango in your rear brake system.
hope this helps sorry it vague if you still cant get it to work let me know ill describe it better
phaze2
08-24-2005, 06:21 PM
Well I havent gotten it yet, but as i understand theres a cylinder at the hand brake, which then taps into either the calipher (stock one) or into the stock rear brake cylinder). I was thinking that Id hold down both the pedal and the hand lever, then open bleeder at the calipher and let air/fluid come out. Then if still mushy I would open the cylinder on the lever, pump the lever until no air bubbles came out, seal the cylinder, so the same for the pedal, and then the calipher bleeding thing again. Sound good...or is my order/technique off?