Bent wheels

[Shookones]

Anyone try n bend there wheel back after hittin a curb pot hole..do they make a tool to fit the lip? i kno they have one for steal wheels on cars.. think ima take the tire off n heat it up a bit see wat happns

[gixxerlife]

I bent mine a bit but was able to beat it back to shape with a hard rubber/plastic mallet..... I've heard of peop's using JP weld and redefining the bead seat so it holds air--But thats lot only bikes....

[bs-stunting]

it depends how bad it is..if its a fairly small bent lip you can hit it back but if its a decent bent then your pretty much screwed..you will end up crackin the wheel...happen to me a couple times...exspecially the front

[f4istunna]

you can bend back with a rubber mallet if it isnt too bad, i've cracked one trying to over do it before

[warbuk]

i bent mine back in shape using a 2 inch nylon bar and a 3 lb hammer.

[Everett]

i used a hydrolic press and alot of time. it worked. it was pretty bad too. guess im lucky