stock clipons??

[black03636]

Can you just flip you stock clipons over and use them still or do you have to go buy vortex??? :shrugg

[vetter]

flip them

[black03636]

thanks veeter...what bars r u running on ur 636???

[vetter]

pro taper cr high i think. no clue really. that jsut sounds familiar.

and no im not going out to the garage to check. in indiana we have this thing called winter. and it fucking sucks.

[black03636]

i dont blame you....in florida its like 70 degrees here and im freezin my balls off....

[nags]

i dont blame you....in florida its like 70 degrees here and im freezin my balls off....

Same here. Got the floor heaters blazing.

[turtle]

Same here. Got the floor heaters blazing.
you fuckers....it is 8 degrees here right now...and its just warming up when i left for work at 6:30 this morning

[Mikey Free]

CT was 0 degrees at 8 this morning

[vetter]

friday its gonna be sunny and 20 degrees out.


i think im might ride during this "heat wave"

[Everett]

um, here is Iowa, its negative when i get up at 730 and the wind makes it feel like -25 our heat wave was 8degrees with snow.

[louisvillerider]

i dont blame you....in florida its like 70 degrees here and im freezin my balls off....

i feel so bad for you guys :hammer if it gets any colder you might have to turn the AIR CONDITIONER OFF!

flip them

dont forget.... left clip on goes on the right... and vice versa, and you will have to drill a set hole for the throttle assembly.

[Danger_Dave]

i flipped the ones on my f4i and feel pretty comfortable except they are not flush with the forks, they are not on there all the way, ya know cuz the tapered part hits the bolt on the triple

[black03636]

could i just un bolt the clipons from the triple tree and turn them out and tighten them back down??? :shrugg

[f4istunna]

i did that w/ my f4i just turned em out, i like the way they feel, had to grind the little notch on the bottom of them off though.