'93 900RR CLEAN TITLE!

[JONESER]

Full plastics. 1 small dent in the tank, plastics are all good, polished frame, swingarm and upper triple. CLEAN TITLE!!

I spun a bearing in it 2 years ago and attempted to rebuild the motor myself with no prior experience. It all went good but 300 miles and $700 in parts later, it made another noise. Not the same as a spun bearing but a noise and I didn't want to chance messing up the $300 crank job and the new rings & bearings. I shut it off and trucked it back to the house where it has sat for the 2 years. I bought a '94 900RR that I've riden since then. I don't have the time/money or motor knowledge to see what's wrong with it.

I'm in the Tampa area

$2500 OBO



http://img505.imageshack.us/img505/3904/both900rrsingarage1hs1.jpg (http://imageshack.us)


http://img505.imageshack.us/img505/4991/both900rrsingarage7xb0.jpg (http://imageshack.us)

Here's the bike with white plastics
http://img479.imageshack.us/img479/705/93rrinfrontofthehouse1hq5.jpg (http://imageshack.us)

[JONESER]

Bumparoo

[1BADZ]

Bumparoo

i got a motor....2 actually.
one runs, the other has good parts(head, etc...rings are toast, cylinder walls and pistons are fucked, everything else is good....)
350$$$for both

[JONESER]

i got a motor....2 actually.
one runs, the other has good parts(head, etc...rings are toast, cylinder walls and pistons are fucked, everything else is good....)
350$$$for both

Shit man... Where you located? I'd rather keep the bike than sell it but like I said, the thing has been setting for 2 years and I'm tired of looking at it.

I'm wanting to get a civic to save on some gas.... Know anyone looking to get rid of one that might wanna trade?

I'll keep the motors in mind though...

[1BADZ]

Shit man... Where you located?

Asheville NC.
their both 919cm3. i dont deal with the 893's...the 919's will fit in the 893 frames though...

[wil2xs]

Are you going to sell it or keep it? Can I buy your cage?