will a 636 front end fit on f4i

[johnforlife]

will a 2005 636 front end fit on a f4i or how hard is it to make work...i have seen them on a few bikes i was just wondering if it will fit on?

[alfmoney]

will a 2005 636 front end fit on a f4i or how hard is it to make work...i have seen them on a few bikes i was just wondering if it will fit on?

you need 929 triples

[johnforlife]

oh ok thanks alf

[PrettyBoy Stuntz]

you need 929 triples

+1.... head tubes are the same but your probably gonna have to put the bearing races from the 636 into the f4i frame too...

[asphaltassault]

you need 929 triples

negative! lower triple on 636 is 52mm and the 929 is 54mm.

[asphaltassault]

+1.... head tubes are the same but your probably gonna have to put the bearing races from the 636 into the f4i frame too...

the 636 head tube is too big.

[johnforlife]

so how do you do it?

[PrettyBoy Stuntz]

if the head tubes are too big look for bearings that have the some OD as f4i head tube but the same ID as the 636

[johnforlife]

i heard the id of your butt hole is that same od as your girls dildo...is that true?

[PrettyBoy Stuntz]

i heard the id of your butt hole is that same od as your girls dildo...is that true?

only on saturdays following a full with with a lunar eclipse on the solstice of the summer months

[johnforlife]

haha im mad i missed that show on sat gary told me all about it

[D-Buck D.F.L]

so how do you do it?


Use duct tape..

[johnforlife]

its not your bike

[carm3twenty2]

like this,

[fatheadon1]

i got zip ties and a welder and austin on speed dial we can do it :thumbsup

[asphaltassault]

ok i didnt want to explain but here we go:

-press stem out of f4i lower triple
-press stem out of 636 lower triple
-machine a press in bushing/spacer to press fit(a couple thousandths small for really tight fit) on the f4i stem and aht 636 triple
-press the bushing into 636 triple
-press stem in to 636 triple with bushing pressed in already
-then make bushing for the top so the f4i stem doesnt have any play in the 636 top triple.

[D-Buck D.F.L]

o that sounds easy as shit:Argh: haha

[asphaltassault]

yeah and good luck pressin everything apart without fuckin up the triple i went to press my stem out of my 636 triple it was real tight!

[MikeM]

1mm shims, 929 triples?

[asphaltassault]

shims are a little sketchy i was thinking the same thing i was going to use spring steel but then i bought a rc51 front end.

[MikeM]

shims are a little sketchy i was thinking the same thing i was going to use spring steel but then i bought a rc51 front end.

thats the hottness. how much?